Laparoscopic Monopolar L-Hook & Spatula
Manufacturer in India

A monopolar L-hook is a laparoscopic active electrode with an angled hook-shaped distal tip. It is intended for connection to a compatible monopolar electrosurgical system.

It is a laparoscopic monopolar electrode with a flatter and broader distal profile than an L-hook.

The primary difference is the distal-tip geometry. An L-hook has an angled hook profile, while a spatula has a broad, flat profile.

Bharat Surgical publishes a 5 mm L-hook, a 3/5 mm monopolar spatula and a selected 5–8 mm L-hook-with-suction configuration.

A 3/5 mm monopolar spatula electrode is listed. Confirm the exact available diameter and product code when ordering.

Yes. Standard Teflon-listed and ceramic-beak 5 mm L-hook variants are published.

A reusable L-hook-with-suction model is specifically listed. Reusability and cycle limitations for every other model should be confirmed from its instructions for use.

Yes. Bharat Surgical lists a 5 mm ceramic-beak L-hook.

The standard 5 mm L-hook listing identifies Teflon as its material. Confirm the precise location and extent of the Teflon component before procurement.

Yes. A reusable stainless-steel L-hook configuration with suction is listed in the 5–8 mm range.

It is likely to require connection to a compatible suction system, but the exact connector and tubing requirement must be confirmed for the selected model.

Cable inclusion is model- and quotation-specific. Request written confirmation if a cable is required.

No. Compatibility must be confirmed using the generator brand, model, output receptacle, active cable and instrument connector.

A monopolar electrosurgical system generally includes a compatible patient-return pathway. The generator manufacturer’s instructions determine the approved return-electrode system.

No. Monopolar and bipolar instruments use different electrical configurations and should not be interchanged.

The trocar must accommodate the instrument shaft diameter. Confirm the trocar’s internal working diameter and the instrument’s actual outer diameter.

Working length is model-specific. A separate hook listing mentions 330 mm, but this dimension must be confirmed for the exact monopolar product code.

It may be possible when the instrument diameter, reducer and trocar are compatible. Verify all three dimensions before use.

Check the complete insulated section for cracks, cuts, pinholes, peeling, discoloration and exposed metal, following the device instructions and hospital protocol.

It should be removed from service and assessed by qualified personnel. Do not continue using an instrument when its electrical insulation is compromised.

Inspect the ceramic component for chips, cracks, looseness and other visible damage. Follow the manufacturer’s inspection criteria.

The outer surfaces and internal suction pathway must be cleaned according to the model-specific instructions for use and the hospital’s validated CSSD procedure.

Only if it is permitted by the instrument manufacturer’s instructions. Do not assume every insulated electrosurgical instrument supports the same cleaning method.

Use only the validated sterilization method and parameters stated for the selected product. Obtain the current IFU before introducing the instrument into the CSSD workflow.

Yes. Hospitals can request quantity-based quotations for replacement, standardization, new OT installations and tender requirements.

Dealer and distributor pricing can be requested with the required models, quantities, market and delivery location.

Provide the tip type, diameter, length, generator model, cable connector, quantity, suction requirement and delivery destination.

Yes. Photographs of the generator socket, active-cable ends and existing instrument connector can assist identification, although documented specifications should determine final compatibility.